Skip to main content
615 Vents, dryer vent and air duct cleaning in Nashville TN 615-431-3789

Duct Repair, Sealing & Replacement

Flex duct replacement that removes sagging, kinked and torn runs and restores steady airflow

We replace old, kinked or torn flexible duct with new, properly stretched and supported runs and sealed connections.

Call or text today615-431-3789

Request a site visit

Tell us about your project. We will contact you to confirm the details and set up a time to visit.

Or call 615-431-3789

By sending this you agree that we may contact you about your project. See our Privacy Policy.

Prefer to type? Text your request to 615-431-3789

Flex Duct Replacement

Flexible duct is common and practical, but it does not age well. It sags between supports, kinks at bends, tears when someone steps on it and the inner liner can fall apart. A kink or a sag can cut airflow to a room by a surprising amount.

We replace the flex runs that are damaged with new insulated flex duct, stretched tight, cut to the right length and supported with wide straps. We use proper collars, tape and mastic at each connection and keep bends gentle. We also look for what damaged the old duct: pests, a hot attic, pulling or crushing. Replacing worn flex is a practical fix in many Nashville attics and crawl spaces.

What you get

Done right, from the first walk-through

01

New flex runs

Insulated duct cut to length and stretched tight.

02

Proper supports

Wide straps stop sagging and kinks.

03

Sealed collars

Connections are sealed at both ends.

04

Gentle bends

Routes avoid tight turns that choke airflow.

The process

How your service comes together

  1. 1

    Inspect the runs

    We check each flex run for damage and sag.

  2. 2

    Replace and support

    We install new runs and straps and seal the ends.

  3. 3

    Test the airflow

    We check each register after replacement.

FAQ

Common questions about flex duct replacement

Why does flex duct fail?

Sagging, kinks, tears, heat and age all take a toll, and pests may chew it.

Can flex duct be repaired instead?

Small tears can be sealed, but kinked, sagging or brittle runs are better replaced.

How long should a flex run be?

As short and straight as the layout allows, since long runs with turns reduce airflow.

Let us help with your flex duct replacement

Call, text or send the form. Tell us about the home or building, what you have noticed and what you would like, and we will take it from there.

615-431-3789Text